Peptide Chemistry
CJC-1295 no DAC and Ipamorelin: sequence, formula and weight
By the NexXGen Research Team · Updated November 18, 2026 · 5 min read
Key takeaways
- CJC-1295 no DAC and Ipamorelin are two separate synthetic peptides. The blend vial holds 5 mg of each.
- CJC-1295 no DAC: 29 amino acids, formula C152H252N44O42, molecular weight about 3367.9 g/mol, CAS number 863288-34-0.
- Ipamorelin: five residues, formula C38H49N9O5, molecular weight about 711.9 g/mol, CAS number 170851-70-4.
- A lab report gives purity by HPLC. Some also give the amount per vial or a mass for identity, so read what the report for your lot shows.
- For in-vitro, laboratory research use only.
CJC-1295 no DAC is a synthetic peptide of 29 amino acids with the formula C152H252N44O42, a molecular weight of about 3367.9 g/mol and the CAS number 863288-34-0. Ipamorelin is a synthetic peptide of five residues with the formula C38H49N9O5, a molecular weight of about 711.9 g/mol and the CAS number 170851-70-4.
This guide gives laboratory staff both compounds’ identifiers, the values to expect on an analytical report, and storage notes for the lyophilized powder. NexXGen Peptides lists the two together as the CJC-1295 no DAC 5 mg / Ipamorelin 5 mg blend, and singly as CJC-1295 no DAC 5 mg and Ipamorelin 10 mg.
What is the amino acid sequence of CJC-1295 no DAC?
In three-letter code the sequence is Tyr-D-Ala-Asp-Ala-Ile-Phe-Thr-Gln-Ser-Tyr-Arg-Lys-Val-Leu-Ala-Gln-Leu-Ser-Ala-Arg-Lys-Leu-Leu-Gln-Asp-Ile-Leu-Ser-Arg-NH2. In one-letter code it is YADAIFTQSYRKVLAQLSARKLLQDILSR, where the A at position 2 stands for D-alanine.
The 29 residues run from tyrosine at the N-terminus to arginine at the C-terminus. Leucine appears five times, at positions 14, 17, 22, 23 and 27. Alanine appears four times; the one at position 2 is D-alanine, the only D-amino acid in the chain.
What is the sequence of Ipamorelin?
Ipamorelin has five residues: Aib-His-D-2Nal-D-Phe-Lys-NH2. Aib is 2-aminoisobutyric acid, a non-standard residue. D-2Nal is 3-(2-naphthyl)-D-alanine, a naphthylalanine, and D-Phe is D-phenylalanine, so two of the five are D-amino acids. Histidine and lysine are the other two.
Two points hold for both peptides. Each chain ends in a C-terminal amide, written NH2. Neither contains cysteine, so neither forms disulfide bonds and each stays a single linear chain.
What are the molecular formulas and molecular weights?
The formula of CJC-1295 no DAC, C152H252N44O42, counts 152 carbon, 252 hydrogen, 44 nitrogen and 42 oxygen atoms. Its average molecular weight is about 3367.9 g/mol and its monoisotopic mass is 3365.89 Da. Our product pages show 3367.896.
For Ipamorelin the formula is C38H49N9O5: 38 carbon, 49 hydrogen, 9 nitrogen and 5 oxygen atoms. The average molecular weight comes to about 711.9 g/mol and the monoisotopic mass to 711.39 Da. Our product pages show 711.86.
Small differences between sources come from rounding. The monoisotopic mass counts only the most common isotope of each element, so it is slightly lower than the average weight. A mass spectrum is checked against one figure or the other, depending on how the laboratory reports it.
All four figures describe the peptides alone. Synthetic peptides are often supplied as a salt, commonly acetate or trifluoroacetate, and the powder also holds some water. The mass of powder in a vial and the mass of peptide are therefore not the same number.
What should the blend look like on an analytical report?
| Test | What it confirms | What to expect for these two peptides |
|---|---|---|
| Mass spectrometry, when reported | Identity | A figure that fits each peptide, monoisotopic or average. Calculated electrospray ions for CJC-1295 no DAC: about m/z 1122.97 (three charges), 842.48 (four charges) and 674.19 (five charges). For Ipamorelin: about m/z 712.39 (one charge) and 356.70 (two charges), or 734.37 with sodium in place of the proton |
| HPLC with UV detection | Purity | Two main peaks, one for each peptide, read at about 214 to 220 nm. Ipamorelin also absorbs at about 280 nm; CJC-1295 no DAC absorbs only weakly there |
| Content, when reported | Amount of each peptide in the vial | A figure in mg for each peptide to compare with the sizes on the label |
| Net peptide content, when reported | Share of the powder that is peptide | A percentage below 100, because salt and water are part of the powder |
| Appearance | Physical form | Lyophilized powder. Our product page describes a solid, white powder |
The report for the lot in hand is the source of truth. Posted reports are on the Certificates of Analysis page.
How should the lyophilized blend be stored?
The listing is 10 mg of lyophilized powder in a 3 mL vial: 5 mg of CJC-1295 no DAC and 5 mg of Ipamorelin. Our product page gives storage at 25°C or below, away from heat, light and moisture. Keep the vial sealed between openings.
What should a researcher check?
- Names and sizes. Both compounds and their sizes on the report match the label.
- Lot number. The lot or batch on the vial is the one on the report.
- Purity. The report gives an HPLC purity figure for that lot.
- Mass, where the report gives one. It agrees with the values in the table above.
Research-use note
All NexXGen Peptides compounds are intended strictly for in-vitro research, laboratory and analytical purposes. They are not for human or animal use and must be handled only by qualified researchers aged 21 or older. Nothing in this article is medical advice.
Frequently asked questions
How many amino acids are in CJC-1295 no DAC and in Ipamorelin?
Twenty-nine and five. Twelve different amino acids make up CJC-1295 no DAC, because nine of them appear more than once. All five residues of Ipamorelin are different.
What are the CAS numbers for CJC-1295 no DAC and Ipamorelin?
863288-34-0 for CJC-1295 no DAC and 170851-70-4 for Ipamorelin.
Is CJC-1295 no DAC the same compound as CJC-1295 with DAC?
No. They are different compounds with different identifiers. CJC-1295 with DAC has the formula C165H269N47O46, a molecular weight of about 3647.2 g/mol and the CAS number 446262-90-4.
Can both peptides be read at 280 nm on HPLC?
Ipamorelin can, because its naphthylalanine residue absorbs at about that wavelength. CJC-1295 no DAC has two tyrosine residues and no tryptophan, so its signal there is weak. Detection of both can rely on the peptide bonds, which absorb at about 214 to 220 nm.
Does either peptide contain disulfide bonds?
No. Neither sequence has cysteine, so each peptide is one linear chain.
